? Wenn nicht erstell diesen Eintrag mal. Leider kann ich dir das nicht verifizieren da xawtv bei mir derzeit nicht läuft und ich andere eh Software verwende.[global]
freqtab = europe-west
scantv -o ~/.xawtv
Das äußert sich wie ...?Annelie schrieb:weil xawtv4 keine frequenztabelle findet.
Dann öffnet sich brav xawtv4. Ich habe sogar ein Fernsehbild, das hat er von kdetv übernommen. Mitten im Fernsehbild steht:anneliecordes@JesusistdieLiebe:~> xawtv4
This is xawtv 4.0-pre, running on Linux/i686 (2.6.18.8-0.5-default)
Vielleicht hilft das ja weiter bei der Fehlersuche. Gruß Anneliefreqtab: unknown table europe-west station "0" not found.
=> http://linux.bytesex.org/xawtv/faq4.htmlQ: should I use xawtv 4.x
Main focus of the current development is support for digital TV, i.e. DVB, maybe also ATSC in near future. So if you have a DVB card and are looking for software you can use give it a try. Please note that most documentation hasn't been updated since 3.x and thus is outdated at the moment. Most useful piece of information is this FAQ and the NEW_IN_4 file in the source tarball.
Analog TV support is there as well, but it isn't completely (re-)implemented yet and also not tested very much. It basically works, but not as good as in 3.x yet. That will change some day as I don't plan to maintain 3.x forever, hopefully sooner than later, just need to find enougth time to get it done. If you want something which just works, better go with 3.x.
Q: should I use xawtv 4.x
Main focus of the current development is support for digital TV, i.e. DVB, maybe also ATSC in near future. So if you have a DVB card and are looking for software you can use give it a try. Please note that most documentation hasn't been updated since 3.x and thus is outdated at the moment. Most useful piece of information is this FAQ and the NEW_IN_4 file in the source tarball.
Analog TV support is there as well, but it isn't completely (re-)implemented yet and also not tested very much. It basically works, but not as good as in 3.x yet. That will change some day as I don't plan to maintain 3.x forever, hopefully sooner than later, just need to find enougth time to get it done. If you want something which just works, better go with 3.x.