Götterdämmerung
Newbie
Hallo Leute habe ein Problem.
Ein bekannter hat mein Stick unter Windos einfach abgezogen und jetzt wird unter Kubuntu 7.10 der Stick nicht richtig erkannt bzw. gar nicht mehr
unter der Konsole mit dem Befehl "dmesg" bekomme ich folgende Meldung.
[ 2366.604425] Initializing USB Mass Storage driver...
[ 2366.604929] scsi0 : SCSI emulation for USB Mass Storage devices
[ 2366.605728] usb-storage: device found at 5
[ 2366.605732] usb-storage: waiting for device to settle before scanning
[ 2366.606095] usbcore: registered new interface driver usb-storage
[ 2366.606185] USB Mass Storage support registered.
[ 2371.605107] usb-storage: device scan complete
[ 2371.606328] scsi 0:0:0:0: Direct-Access USB DRIVE 2.00 PQ: 0 ANSI: 2
[ 2373.767116] ready
[ 2373.768725] sd 0:0:0:0: [sda] 2048000 512-byte hardware sectors (1049 MB)
[ 2373.770898] sd 0:0:0:0: [sda] Write Protect is off
[ 2373.770903] sd 0:0:0:0: [sda] Mode Sense: 03 00 00 00
[ 2373.770906] sd 0:0:0:0: [sda] Assuming drive cache: write through
[ 2373.778259] sd 0:0:0:0: [sda] 2048000 512-byte hardware sectors (1049 MB)
[ 2373.780362] sd 0:0:0:0: [sda] Write Protect is off
[ 2373.780368] sd 0:0:0:0: [sda] Mode Sense: 03 00 00 00
[ 2373.780371] sd 0:0:0:0: [sda] Assuming drive cache: write through
[ 2373.780376] sda: sda4
[ 2373.784213] sd 0:0:0:0: [sda] Attached SCSI removable disk
[ 2373.805604] sd 0:0:0:0: Attached scsi generic sg0 type 0
[ 2974.954040] loop: module loaded
[ 3029.829209] FAT: invalid media value (0x31)
[ 3029.829216] VFS: Can't find a valid FAT filesystem on dev loop0.
[ 3066.596381] FAT: invalid media value (0x31)
[ 3066.596389] VFS: Can't find a valid FAT filesystem on dev loop0.
[ 3095.820844] FAT: invalid media value (0x31)
[ 3095.820852] VFS: Can't find a valid FAT filesystem on dev loop0.
[ 3359.450713] usb 3-1.1: USB disconnect, address 5
[ 3362.977884] usb 3-1.1: new high speed USB device using ehci_hcd and address 6
[ 3363.074589] usb 3-1.1: configuration #1 chosen from 1 choice
[ 3363.074925] scsi1 : SCSI emulation for USB Mass Storage devices
[ 3363.075094] usb-storage: device found at 6
[ 3363.075097] usb-storage: waiting for device to settle before scanning
[ 3368.073355] usb-storage: device scan complete
[ 3368.075819] scsi 1:0:0:0: Direct-Access USB DRIVE 2.00 PQ: 0 ANSI: 2
[ 3369.161259] ready
[ 3369.162868] sd 1:0:0:0: [sda] 2048000 512-byte hardware sectors (1049 MB)
[ 3369.163642] sd 1:0:0:0: [sda] Write Protect is off
[ 3369.163646] sd 1:0:0:0: [sda] Mode Sense: 03 00 00 00
[ 3369.163649] sd 1:0:0:0: [sda] Assuming drive cache: write through
[ 3369.167897] sd 1:0:0:0: [sda] 2048000 512-byte hardware sectors (1049 MB)
[ 3369.168786] sd 1:0:0:0: [sda] Write Protect is off
[ 3369.168790] sd 1:0:0:0: [sda] Mode Sense: 03 00 00 00
[ 3369.168793] sd 1:0:0:0: [sda] Assuming drive cache: write through
[ 3369.168798] sda: sda4
[ 3369.170012] sd 1:0:0:0: [sda] Attached SCSI removable disk
[ 3369.170067] sd 1:0:0:0: Attached scsi generic sg0 type 0
So für mich sieht das so aus als wenn der noch funzt.
Unter Wimdows wird das "raw" Dateisystem angezeigt.
Meine Frage ist, sind die Daten weg, wenn "nein" wie retten?
Weil mit "fsck.vfat", "fsck.nfs" ging das nicht.
Wenn das mit dem Retten nicht klappt wäre nicht schlimm aber wie mache ich den wieder lauffähig habe echt keine Ahnung mehr.
mfg
Götterdämmerung
P.S.:
Bin Noob
Ein bekannter hat mein Stick unter Windos einfach abgezogen und jetzt wird unter Kubuntu 7.10 der Stick nicht richtig erkannt bzw. gar nicht mehr
unter der Konsole mit dem Befehl "dmesg" bekomme ich folgende Meldung.
[ 2366.604425] Initializing USB Mass Storage driver...
[ 2366.604929] scsi0 : SCSI emulation for USB Mass Storage devices
[ 2366.605728] usb-storage: device found at 5
[ 2366.605732] usb-storage: waiting for device to settle before scanning
[ 2366.606095] usbcore: registered new interface driver usb-storage
[ 2366.606185] USB Mass Storage support registered.
[ 2371.605107] usb-storage: device scan complete
[ 2371.606328] scsi 0:0:0:0: Direct-Access USB DRIVE 2.00 PQ: 0 ANSI: 2
[ 2373.767116] ready
[ 2373.768725] sd 0:0:0:0: [sda] 2048000 512-byte hardware sectors (1049 MB)
[ 2373.770898] sd 0:0:0:0: [sda] Write Protect is off
[ 2373.770903] sd 0:0:0:0: [sda] Mode Sense: 03 00 00 00
[ 2373.770906] sd 0:0:0:0: [sda] Assuming drive cache: write through
[ 2373.778259] sd 0:0:0:0: [sda] 2048000 512-byte hardware sectors (1049 MB)
[ 2373.780362] sd 0:0:0:0: [sda] Write Protect is off
[ 2373.780368] sd 0:0:0:0: [sda] Mode Sense: 03 00 00 00
[ 2373.780371] sd 0:0:0:0: [sda] Assuming drive cache: write through
[ 2373.780376] sda: sda4
[ 2373.784213] sd 0:0:0:0: [sda] Attached SCSI removable disk
[ 2373.805604] sd 0:0:0:0: Attached scsi generic sg0 type 0
[ 2974.954040] loop: module loaded
[ 3029.829209] FAT: invalid media value (0x31)
[ 3029.829216] VFS: Can't find a valid FAT filesystem on dev loop0.
[ 3066.596381] FAT: invalid media value (0x31)
[ 3066.596389] VFS: Can't find a valid FAT filesystem on dev loop0.
[ 3095.820844] FAT: invalid media value (0x31)
[ 3095.820852] VFS: Can't find a valid FAT filesystem on dev loop0.
[ 3359.450713] usb 3-1.1: USB disconnect, address 5
[ 3362.977884] usb 3-1.1: new high speed USB device using ehci_hcd and address 6
[ 3363.074589] usb 3-1.1: configuration #1 chosen from 1 choice
[ 3363.074925] scsi1 : SCSI emulation for USB Mass Storage devices
[ 3363.075094] usb-storage: device found at 6
[ 3363.075097] usb-storage: waiting for device to settle before scanning
[ 3368.073355] usb-storage: device scan complete
[ 3368.075819] scsi 1:0:0:0: Direct-Access USB DRIVE 2.00 PQ: 0 ANSI: 2
[ 3369.161259] ready
[ 3369.162868] sd 1:0:0:0: [sda] 2048000 512-byte hardware sectors (1049 MB)
[ 3369.163642] sd 1:0:0:0: [sda] Write Protect is off
[ 3369.163646] sd 1:0:0:0: [sda] Mode Sense: 03 00 00 00
[ 3369.163649] sd 1:0:0:0: [sda] Assuming drive cache: write through
[ 3369.167897] sd 1:0:0:0: [sda] 2048000 512-byte hardware sectors (1049 MB)
[ 3369.168786] sd 1:0:0:0: [sda] Write Protect is off
[ 3369.168790] sd 1:0:0:0: [sda] Mode Sense: 03 00 00 00
[ 3369.168793] sd 1:0:0:0: [sda] Assuming drive cache: write through
[ 3369.168798] sda: sda4
[ 3369.170012] sd 1:0:0:0: [sda] Attached SCSI removable disk
[ 3369.170067] sd 1:0:0:0: Attached scsi generic sg0 type 0
So für mich sieht das so aus als wenn der noch funzt.
Unter Wimdows wird das "raw" Dateisystem angezeigt.
Meine Frage ist, sind die Daten weg, wenn "nein" wie retten?
Weil mit "fsck.vfat", "fsck.nfs" ging das nicht.
Wenn das mit dem Retten nicht klappt wäre nicht schlimm aber wie mache ich den wieder lauffähig habe echt keine Ahnung mehr.
mfg
Götterdämmerung
P.S.:
Bin Noob