hi
Meine Digitale Knipstüte(DC2300) will lässt sich nicht bei meiner SuSE 9.1 (downloadversion) mounten lasssen. Bei den Vorgängern SuSE 7.2/8.2 funktionierte die ganze Sache noch.In /media ist ein entsprechender Eintrag, nach dem anschliessen der Kamera friert das System ein.Andere USB-Geräte (Stick,Card-Reader) funktionieren problemlos. Wie kriege ich das wieder hin, das das gerät automatisch gemountet wird- händisch ist nicht so toll-Familienkiste.
in /var/log/messages erscheint:
.
.
Nov 28 19:18:54 linux kernel: hub 1-2:1.0: connect-debounce failed, port 2 disabled
Nov 28 19:18:59 linux kernel: usb 1-2.2: new full speed USB device using address 5
Nov 28 19:18:59 linux kernel: usb 1-2.2: Product: DC2300
Nov 28 19:18:59 linux kernel: usb 1-2.2: Manufacturer: USB
Nov 28 19:18:59 linux kernel: usb 1-2.2: SerialNumber: DSC 2002
Nov 28 19:19:00 linux /etc/hotplug/usb.agent[5485]: need a device for this command
Nov 28 19:19:05 linux kernel: usb 1-2.2: control timeout on ep0in
Nov 28 19:19:05 linux kernel: scsi1 : SCSI emulation for USB Mass Storage devices
Nov 28 19:19:05 linux kernel: Vendor: DC2300 Model: CAMERA DC2300 Rev: 1.00
Nov 28 19:19:05 linux kernel: Type: Direct-Access ANSI SCSI revision: 02
Nov 28 19:19:05 linux kernel: SCSI device sda: 500689 512-byte hdwr sectors (256 MB)
Nov 28 19:19:05 linux kernel: sda: assuming Write Enabled
Nov 28 19:19:05 linux kernel: sda: assuming drive cache: write through
Nov 28 19:19:05 linux /etc/hotplug/block.agent[5574]: try 1 while waiting for /block/sda's bus_id 1:0:0:0
Nov 28 19:19:05 linux kernel: sda: sda1
Nov 28 19:19:05 linux kernel: Attached scsi removable disk sda at scsi1, channel 0, id 0, lun 0
Nov 28 19:19:05 linux kernel: Attached scsi generic sg0 at scsi1, channel 0, id 0, lun 0, type 0
Nov 28 19:19:05 linux kernel: USB Mass Storage device found at 5
Nov 28 19:19:06 linux /etc/hotplug/block.agent[5603]: new block device /block/sda/sda1
Nov 28 19:19:06 linux /etc/hotplug/block.agent[5574]: waiting for /var/lock/block.agent.lock, process 5603 holds it
Nov 28 19:19:21 linux /etc/hotplug/block.agent[5603]: mount by-path/usb-storage-DSC2002:0:0:0p1
Nov 28 19:19:21 linux /etc/hotplug/block.agent[5574]: new block device /block/sda
Nov 28 19:20:08 linux kernel: cdrom: open failed.
Nov 28 19:20:08 linux kernel: udf: registering filesystem
Nov 28 19:20:09 linux kernel: cdrom: open failed.
Nov 28 19:20:09 linux submountd: mount failure, No medium found
Nov 28 19:20:09 linux kernel: subfs: unsuccessful attempt to mount media (256)
Nov 28 19:20:11 linux kernel: cdrom: open failed.
Nov 28 19:20:13 linux kernel: cdrom: open failed.
Nov 28 19:20:13 linux submountd: mount failure, No medium found
Dann half nur ein reboot aus der Konsole....
thx
bye
Meine Digitale Knipstüte(DC2300) will lässt sich nicht bei meiner SuSE 9.1 (downloadversion) mounten lasssen. Bei den Vorgängern SuSE 7.2/8.2 funktionierte die ganze Sache noch.In /media ist ein entsprechender Eintrag, nach dem anschliessen der Kamera friert das System ein.Andere USB-Geräte (Stick,Card-Reader) funktionieren problemlos. Wie kriege ich das wieder hin, das das gerät automatisch gemountet wird- händisch ist nicht so toll-Familienkiste.
in /var/log/messages erscheint:
.
.
Nov 28 19:18:54 linux kernel: hub 1-2:1.0: connect-debounce failed, port 2 disabled
Nov 28 19:18:59 linux kernel: usb 1-2.2: new full speed USB device using address 5
Nov 28 19:18:59 linux kernel: usb 1-2.2: Product: DC2300
Nov 28 19:18:59 linux kernel: usb 1-2.2: Manufacturer: USB
Nov 28 19:18:59 linux kernel: usb 1-2.2: SerialNumber: DSC 2002
Nov 28 19:19:00 linux /etc/hotplug/usb.agent[5485]: need a device for this command
Nov 28 19:19:05 linux kernel: usb 1-2.2: control timeout on ep0in
Nov 28 19:19:05 linux kernel: scsi1 : SCSI emulation for USB Mass Storage devices
Nov 28 19:19:05 linux kernel: Vendor: DC2300 Model: CAMERA DC2300 Rev: 1.00
Nov 28 19:19:05 linux kernel: Type: Direct-Access ANSI SCSI revision: 02
Nov 28 19:19:05 linux kernel: SCSI device sda: 500689 512-byte hdwr sectors (256 MB)
Nov 28 19:19:05 linux kernel: sda: assuming Write Enabled
Nov 28 19:19:05 linux kernel: sda: assuming drive cache: write through
Nov 28 19:19:05 linux /etc/hotplug/block.agent[5574]: try 1 while waiting for /block/sda's bus_id 1:0:0:0
Nov 28 19:19:05 linux kernel: sda: sda1
Nov 28 19:19:05 linux kernel: Attached scsi removable disk sda at scsi1, channel 0, id 0, lun 0
Nov 28 19:19:05 linux kernel: Attached scsi generic sg0 at scsi1, channel 0, id 0, lun 0, type 0
Nov 28 19:19:05 linux kernel: USB Mass Storage device found at 5
Nov 28 19:19:06 linux /etc/hotplug/block.agent[5603]: new block device /block/sda/sda1
Nov 28 19:19:06 linux /etc/hotplug/block.agent[5574]: waiting for /var/lock/block.agent.lock, process 5603 holds it
Nov 28 19:19:21 linux /etc/hotplug/block.agent[5603]: mount by-path/usb-storage-DSC2002:0:0:0p1
Nov 28 19:19:21 linux /etc/hotplug/block.agent[5574]: new block device /block/sda
Nov 28 19:20:08 linux kernel: cdrom: open failed.
Nov 28 19:20:08 linux kernel: udf: registering filesystem
Nov 28 19:20:09 linux kernel: cdrom: open failed.
Nov 28 19:20:09 linux submountd: mount failure, No medium found
Nov 28 19:20:09 linux kernel: subfs: unsuccessful attempt to mount media (256)
Nov 28 19:20:11 linux kernel: cdrom: open failed.
Nov 28 19:20:13 linux kernel: cdrom: open failed.
Nov 28 19:20:13 linux submountd: mount failure, No medium found
Dann half nur ein reboot aus der Konsole....
thx
bye