• Willkommen im Linux Club - dem deutschsprachigen Supportforum für GNU/Linux. Registriere dich kostenlos, um alle Inhalte zu sehen und Fragen zu stellen.

[gelöst] Waiting for mandatory devices?

Hi,

seit einiger Zeit kommt folgende Meldung in Verbindung mit einer gewissen Wartezeit beim Booten von Suse 10.2

Code:
 Setting up network interfaces:
    lo        
    lo        IP address: 127.0.0.1/8   
done    cipsec0   
              No configuration found for cipsec0
unused    eth0      device: Intel Corporation PRO/Wireless 2200BG Network Connection (rev 05)
    eth0      configuration: wlan-id-00:0e:35:24:0a:3b
    eth0      starting wpa_supplicant
    eth0      (DHCP) . . . . . no IP address yet... backgrounding. 
waiting
    eth1      device: Realtek Semiconductor Co., Ltd. RTL-8139/8139C/8139C+ (rev 10)
    eth1      configuration: eth-id-00:02:3f:17:75:f9
<notice>checkproc: /sbin/dhcpcd 3220
    eth1      (DHCP) . . . . . no IP address yet... backgrounding. 
waiting
Waiting for mandatory devices:  eth-id-00:02:3f:17:75:f9 wlan-id-00:0e:35:24:0a:3b __NSC__
7 6 4 3 1 0 
    eth1      device: Realtek Semiconductor Co., Ltd. RTL-8139/8139C/8139C+ (rev 10)
    eth1      configuration: eth-id-00:02:3f:17:75:f9
    eth1      dhcpcd is still waiting for data
waiting
    eth1      interface could not be set up until now
failed    eth0      device: Intel Corporation PRO/Wireless 2200BG Network Connection (rev 05)
    eth0      configuration: wlan-id-00:0e:35:24:0a:3b
    eth0      dhcpcd is still waiting for data
waiting
    eth0      interface could not be set up until now
failed    dsl1      
doneSetting up service network  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .  .failed

Kann mir einer sagen, was das bedeutet bzw. wie ich diese Wartezeit verkürzen kann? Ich geh über die Realtek-Karte via Alice ins Netz. Unter Yast ist "bei Systemstart" starten aktiviert...

Dankeschön...
 
Aha! Danke für den sehr informativen Link... Nun weiß ich wenigstens was da "abgeht"

:wink:

Dennoch, so richtig weitergebracht hat er mit nicht. Aber ich bin darauf hingewiesen worden, in Yast -> Netzwerkkarten nicht "bei Systemstart" aktivieren sondern "Hot-Plugged".

Und schon hat sich das Problem erledigt! Naja, zumindest kommt jetzt nur noch "DHCP...." mit einer kleineren Wartezeit.

Damit bin ich aber zufrieden.

Nochmals Danke...
 
Oben