Habe es bis jetzt nicht geschafft die USV mit apcupsd zum laufen zu bringen bzw apcupsd zu zeigen hallo da ist ne USV
server:/home/patrick # apctest
2007-01-22 19:44:17 apctest 3.13.9 (28 September 2006) suse
Checking configuration ...
Attached to driver: apcsmart
sharenet.type = DISABLE
cable.type = USB_CABLE
You are using a USB cable type, so I'm entering USB test mode
mode.type = APCSMART_UPS
Setting up the port ...
YYYYYYapctest FATAL ERROR in smartsetup.c at line 171
PANIC! Cannot communicate with UPS via serial port.
Please make sure the port specified on the DEVICE directive is correct,
and that your cable specification on the UPSCABLE directive is correct.
apctest error termination completed
server:/home/patrick #
via USB wird sie aber erkannt wie mir der Befehl dmesg zeigt:
usb 1-2: new device found, idVendor=051d, idProduct=0002
usb 1-2: new device strings: Mfr=3, Product=1, SerialNumber=2
usb 1-2: Product: Back-UPS CS 500 FW:808.q8.I USB FW:q8
usb 1-2: Manufacturer: American Power Conversion
usb 1-2: SerialNumber: 8B0644R10253
Kann mir da jemand helfen wie ich so vermute ich das .conf file von apcupsd anpassen muss?
Gruss
Patrick
server:/home/patrick # apctest
2007-01-22 19:44:17 apctest 3.13.9 (28 September 2006) suse
Checking configuration ...
Attached to driver: apcsmart
sharenet.type = DISABLE
cable.type = USB_CABLE
You are using a USB cable type, so I'm entering USB test mode
mode.type = APCSMART_UPS
Setting up the port ...
YYYYYYapctest FATAL ERROR in smartsetup.c at line 171
PANIC! Cannot communicate with UPS via serial port.
Please make sure the port specified on the DEVICE directive is correct,
and that your cable specification on the UPSCABLE directive is correct.
apctest error termination completed
server:/home/patrick #
via USB wird sie aber erkannt wie mir der Befehl dmesg zeigt:
usb 1-2: new device found, idVendor=051d, idProduct=0002
usb 1-2: new device strings: Mfr=3, Product=1, SerialNumber=2
usb 1-2: Product: Back-UPS CS 500 FW:808.q8.I USB FW:q8
usb 1-2: Manufacturer: American Power Conversion
usb 1-2: SerialNumber: 8B0644R10253
Kann mir da jemand helfen wie ich so vermute ich das .conf file von apcupsd anpassen muss?
Gruss
Patrick