Hallo,
mal wieder so'n Ding.
Ich hätte da eine smb.conf mit
Nach dem '#' kommt ein TAB.
Krieg ich das mit sed raus, in einem shellscript?
In dieser Datei kommen noch mehr Hashtags vor.
Ziel wäre ein 'acl allow execute alway = yes' ohne Hashtag.
MfG
mal wieder so'n Ding.
Ich hätte da eine smb.conf mit
Code:
# acl allow execute alway = yes
Nach dem '#' kommt ein TAB.
Krieg ich das mit sed raus, in einem shellscript?
In dieser Datei kommen noch mehr Hashtags vor.
Ziel wäre ein 'acl allow execute alway = yes' ohne Hashtag.
MfG