[erledigt] K3b opc Fehler ?!

cdrecord dev=/dev/hdb -v -eject -driveropts=burnproof Downloads/myiso.ISO

This is wodim, not cdrecord. Don't expect it to behave like cdrecord in any
way, don't refer to it as "cdrecord". Send problem reports to
debburn-devel@lists.alioth.debian.org, don't bother Joerg Schilling with any
problems caused by this application.
Copyright (C) 2006 cdrkit maintainers, (C) 1994-2006 Joerg Schilling

wodim: No write mode specified.
wodim: Asuming -tao mode.
wodim: Future versions of wodim may have different drive dependent defaults.
TOC Type: 1 = CD-ROM
wodim: Operation not permitted. Warning: Cannot raise RLIMIT_MEMLOCK limits.wodim: Cannot allocate memory. WARNING: Cannot do mlockall(2).
wodim: WARNING: This causes a high risk for buffer underruns.
wodim: Operation not permitted. WARNING: Cannot set RR-scheduler
wodim: Permission denied. WARNING: Cannot set priority using setpriority().
wodim: WARNING: This causes a high risk for buffer underruns.
scsidev: '/dev/hdb'
devname: '/dev/hdb'
scsibus: -2 target: -2 lun: -2
Linux sg driver version: 3.5.27
Warning: Cannot gain SYS_RAWIO capability: Operation not permitted
Possible reason: wodim not installed SUID root.
Using libscg version 'debburn project-0.8ubuntu1+debburn1'.
wodim: Warning: using inofficial version of libscg (debburn project-0.8ubuntu1+debburn1 '@(#)scsitransp.c       1.91 04/06/17 Copyright 1988,1995,2000-2004 J. Schilling').
wodim: Warning: using inofficial libscg transport code version (cdrkit-team-scsi-linux-sg.c-1.86 '@(#)scsi-linux-sg.c   1.86 05/11/22 Copyright 1997 J. Schilling').
Driveropts: 'burnproof'
SCSI buffer size: 64512
atapi: 1
Device type    : Removable CD-ROM
Version        : 0
Response Format: 2
Capabilities   :
Vendor_info    : 'MATSHITA'
Identifikation : 'UJ-831Da        '
Revision       : '1.01'
Device seems to be: Generic mmc2 DVD-R/DVD-RW.
Current: 0x0009
Profile: 0x002B
Profile: 0x001B
Profile: 0x001A
Profile: 0x0013
Profile: 0x0014
Profile: 0x0011
Profile: 0x0010
Profile: 0x000A
Profile: 0x0009 (current)
Profile: 0x0008
Using generic SCSI-3/mmc   CD-R/CD-RW driver (mmc_cdr).
Driver flags   : MMC-3 SWABAUDIO BURNFREE
Supported modes: TAO PACKET SAO
Drive buf size : 1310720 = 1280 KB
FIFO size      : 4194304 = 4096 KB
Track 01: data   251 MB
Total size:      288 MB (28:35.22) = 128642 sectors
Lout start:      288 MB (28:37/17) = 128642 sectors
Current Secsize: 2048
ATIP info from disk:
  Indicated writing power: 5
  Is not unrestricted
  Is not erasable
  Disk sub type: Medium Type B, low Beta category (B-) (4)
  ATIP start of lead in:  -11834 (97:24/16)
  ATIP start of lead out: 359849 (79:59/74)
Disk type:    Short strategy type (Phthalocyanine or similar)
Manuf. index: 24
Manufacturer: SONY Corporation
Blocks total: 359849 Blocks current: 359849 Blocks remaining: 231207
wodim: Operation not permitted. WARNING: Cannot set RR-scheduler
wodim: Permission denied. WARNING: Cannot set priority using setpriority().
wodim: WARNING: This causes a high risk for buffer underruns.
Error: Cannot gain SYS_RAWIO capability, is wodim installed SUID root? Reason: Operation not permitted
Speed set to 4234 KB/s
Starting to write CD/DVD at speed  24.0 in real TAO mode for single session.
Last chance to quit, starting real write    0 seconds. Operation starts.
Waiting for reader process to fill input buffer ... input buffer ready.
BURN-Free is ON.
Performing OPC...
wodim: Success. send opc: scsi sendcmd: no error
CDB:  54 01 00 00 00 00 00 00 00 00
status: 0x2 (CHECK CONDITION)
Sense Bytes: 70 00 03 00 00 00 00 0A 00 00 15 12 73 03 00 00
Sense Key: 0x3 Medium Error, Segment 0
Sense Code: 0x73 Qual 0x03 (power calibration area error) Fru 0x0
Sense flags: Blk 0 (not valid)
cmd finished after 10.145s timeout 60s
wodim: OPC failed.
Writing  time:   13.702s
BURN-Free was never needed.