• Willkommen im Linux Club - dem deutschsprachigen Supportforum für GNU/Linux. Registriere dich kostenlos, um alle Inhalte zu sehen und Fragen zu stellen.

Wer hat Durchblick und kann helfen ???

fmwag

Newbie
Hallo,

nachfolgendes Ergebnis: Suse Linux 9.1 & WLAN PCMCIA-Karte Netgear WG511

linux:/home/FW # rcnetwork restart
Shutting down network interfaces:
eth0 device: Intel Corp. 82801CAM (ICH3) PRO/100 VE (LOM) Ethernet Cont roller (rev 41)
eth0 configuration: eth-id-00:d0:59:33:c5:06 done
eth1 device: Harris Semiconductor D-Links DWL-g650 A1 (rev 01)
eth1 configuration: wlan-bus-pcmcia done
Shutting down service network . . . . . . . . . . . . . done.
Hint: you may set mandatory devices in /etc/sysconfig/network/config
Setting up network interfaces:
lo
lo IP address: 127.0.0.1/8 done
eth0 device: Intel Corp. 82801CAM (ICH3) PRO/100 VE (LOM) Ethernet Cont roller (rev 41)
eth0 configuration: eth-id-00:d0:59:33:c5:06
eth0 (DHCP) . IP/Netmask: 192.168.2.110 / 255.255.255.0 done
eth1 device: Harris Semiconductor D-Links DWL-g650 A1 (rev 01)
eth1 configuration: wlan-bus-pcmcia
eth1 (DHCP) . . . . . no IP address yet... backgrounding. waiting
Setting up service network . . . . . . . . . . . . . . done.
linux:/home/FW # iwconfig
lo no wireless extensions.

eth0 no wireless extensions.

sit0 no wireless extensions.

eth1 IEEE 802.11b/g Nickname:"linux"
Mode:Managed Channel:6 Access Point: 00:00:00:00:00:00
Bit Rate:0kb/s Tx-Power=31 dBm Sensitivity=20/200
Retry min limit:8 RTS thr:2347 B Fragment thr:2346 B
Encryption key:6162-6364-6566-6768-696A-6B6C-6D Security mode:restricted
Link Quality:0 Signal level:0 Noise level:0
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0

linux:/home/FW # cardctl ident
Socket 0:
no product info available
Socket 1:
product info: "Intersil", "ISL3890", "-", "-"
manfid: 0x000b, 0x3890
function: 254 ((null))
linux:/home/FW #

Danke
 
A

Anonymous

Gast
ich würde mal sagen, dass für Deine Netgear evtl der falsche Treiber von SuSE gewählt wird.
Wäre mir neu, dass die Netgearkarten Intesil Chips haben, oder täusche ich mich?
 
Du hast ne Netgear und Suse läd ne D-Link. Schau mal in der /etc/pcmcia/config nach, ob die manfid mit der übereinstimmt, die dir "cardctl ident" liefert. Du kannst dich prinzipiell an meine Anleitung "Netgear MA401 einrichten" halten.
 
Oben