Intel(R) PRO/Wireless 3945 unter SuSE 10, was lief schief?

Hallo,

ich arbeite seit längerer Zeit wieder mit Linux, habe aber Schwierigkeiten bei der Installation der WLAN-Karte und würde mich über ein paar Tipps freuen

Gruß Ren´e

PS: sieht eigentlich alles gut aus:

linux:/home/rmg/Treiber/WLAN/intel-ipw3945-1.0.0/ipw3945-1.0.0 # ./load
Unloaded: ipw3945 ieee80211 ieee80211_crypt
Loaded: ieee80211 ipw3945
Loading ipw3945d.ipw3945d - regulatory daemon
Copyright (C) 2005-2006 Intel Corporation. All rights reserved.
version: 1.7.18
Intel PRO/Wireless 3945ABG Network Connection found at:
/sys/bus/pci/drivers/ipw3945/0000:06:00.0
Daemon launched as pid 7821. Exiting.
..done.
linux:/home/rmg/Treiber/WLAN/intel-ipw3945-1.0.0/ipw3945-1.0.0 # iwconfig eth1 essid "RMG's WLAN"
linux:/home/rmg/Treiber/WLAN/intel-ipw3945-1.0.0/ipw3945-1.0.0 # iwconfig eth1 key xxxxxxxx
linux:/home/rmg/Treiber/WLAN/intel-ipw3945-1.0.0/ipw3945-1.0.0 # iwconfig
lo no wireless extensions.

sit0 no wireless extensions.

eth0 no wireless extensions.

eth1 IEEE 802.11g ESSID:"RMG's WLAN"
Mode:Managed Frequency:2.437 GHz Access Point: 00:04:0E:B3:54:53
Bit Rate=54 Mb/s Tx-Power:15 dBm
Retry limit:15 RTS thrff Fragment thrff
Encryption key:0xxxxxxxxx900-0000-0000-00 Security modepen
Power Managementff
Link Quality=97/100 Signal level=-28 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:882 Missed beacon:0

linux:/home/rmg/Treiber/WLAN/intel-ipw3945-1.0.0/ipw3945-1.0.0 # ifconfig eth1 up
linux:/home/rmg/Treiber/WLAN/intel-ipw3945-1.0.0/ipw3945-1.0.0 # ifconfig
eth0 Protokoll:Ethernet Hardware Adresse 00:13:A9:0E:24:74
inet Adresse:192.168.178.21 Bcast:192.168.178.255 Maske:255.255.255.0
inet6 Adresse: fe80::213:a9ff:fe0e:2474/64 Gültigkeitsbereich:Verbindung
UP BROADCAST NOTRAILERS RUNNING MULTICAST MTU:1500 Metric:1
RX packets:7 errors:0 dropped:0 overruns:0 frame:0
TX packets:59 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 Sendewarteschlangenlänge:1000
RX bytes:1023 (1023.0 b) TX bytes:6192 (6.0 Kb)

eth1 Protokoll:Ethernet Hardware Adresse 00:13:02:05:62:A7
inet6 Adresse: fe80::213:2ff:fe05:62a7/64 Gültigkeitsbereich:Verbindung
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:933 errors:6 dropped:894 overruns:0 frame:0
TX packets:4 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 Sendewarteschlangenlänge:1000
RX bytes:0 (0.0 b) TX bytes:369 (369.0 b)
Interrupt:185 Basisadresse:0xe000 Speicher:cc000000-cc000fff

lo Protokoll:Lokale Schleife
inet Adresse:127.0.0.1 Maske:255.0.0.0
inet6 Adresse: ::1/128 Gültigkeitsbereich:Maschine
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:36 errors:0 dropped:0 overruns:0 frame:0
TX packets:36 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 Sendewarteschlangenlänge:0
RX bytes:2256 (2.2 Kb) TX bytes:2256 (2.2 Kb)

linux:/home/rmg/Treiber/WLAN/intel-ipw3945-1.0.0/ipw3945-1.0.0 # ping fritz.box
ping: unknown host fritz.box




May 13 03:25:59 linux kernel: ACPI: PCI interrupt for device 0000:06:00.0 disabl
ed
May 13 03:25:59 linux kernel: ieee80211_crypt: unregistered algorithm 'NULL'
May 13 03:25:59 linux kernel: ieee80211_crypt: module not supported by Novell, s
etting U taint flag.
May 13 03:25:59 linux kernel: ieee80211_crypt: registered algorithm 'NULL'
May 13 03:25:59 linux kernel: ieee80211: module not supported by Novell, setting U taint flag.
May 13 03:25:59 linux kernel: ieee80211: 802.11 data/management/control stack, 1 .1.12
May 13 03:25:59 linux kernel: ieee80211: Copyright (C) 2004-2005 Intel Corporati on <jketreno@linux.intel.com>
May 13 03:25:59 linux kernel: ipw3945: module not supported by Novell, setting U taint flag.
May 13 03:25:59 linux kernel: ipw3945: Intel(R) PRO/Wireless 3945 Network Connec tion driver for Linux, 1.0.0
May 13 03:25:59 linux kernel: ipw3945: Copyright(c) 2003-2006 Intel Corporation
May 13 03:25:59 linux kernel: ACPI: PCI Interrupt 0000:06:00.0[A] -> GSI 18 (lev el, low) -> IRQ 185
May 13 03:25:59 linux kernel: PCI: Setting latency timer of device 0000:06:00.0 to 64
May 13 03:25:59 linux kernel: ipw3945: Detected Intel PRO/Wireless 3945ABG Netwo rk Connection
May 13 03:25:59 linux kernel: ipw3945: Detected geography ABG (13 802.11bg chann els, 23 802.11a channels)
May 13 03:25:59 linux ifup-wireless: Could not set encryption, device does not s upport it
May 13 03:28:09 linux kernel: ieee80211_crypt_wep: module not supported by Novell, setting U taint flag.
May 13 03:28:09 linux kernel: ieee80211_crypt: registered algorithm 'WEP'
May 13 03:29:49 linux kernel: eth1: no IPv6 routers present

Guten Morgen,
was passiert denn, wenn Du mal testweise die Verschlüsselung ausschaltest und das Broadcasting erlaubst?

Die andere Netzwerkkarte, auf "bei Kabelanschluss" einstellen.

mfg
spezi

Danke für den Tipp, jetzt gehts
Gruß, René

Guten Abend oder besser Guten Morgen,
vergiss aber nicht die Verschlüsselung wieder einzurichten.
... und vielleicht [Gelöst] in die Überschrift reinschreiben

mfg
spezi

Hallo

ich versuche auch den WLAN Treiber zum laufen zu bringen.

Wenn ich Deamon starte bekomme ich folgende Meldung :

ipw3945d - regulatory daemon
Copyright (C) 2005-2006 Intel Corporation. All rights reserved.
version: 1.7.18
2006-11-11 17:51:18: ERROR: opening /sys/bus/pci/drivers/ipw3945:
No such file or directory (2)
2006-11-11 17:51:18: ERROR: Could not find Intel PRO/Wireless 3945ABG Network Connection


Beim Aufruf von modprobe bekomme ich diese Meldung
FATAL: Error inserting ipw3945 (/lib/modules/2.6.16.21-0.25-smp/weak-updates/ipw3945.ko): Unknown symbol in module, or unknown parameter (see dmesg)
2006-11-11 17:55:12: ERROR: opening /sys/bus/pci/drivers/ipw3945:
No such file or directory (2)
2006-11-11 17:55:12: ERROR: Could not find Intel PRO/Wireless 3945ABG Network Connection
FATAL: Error running install command for ipw3945


Hast Du eine Ahnung was das bedeuten kann

Danke im Voraus

Was sind denn die letzten Zeilen der Ausgabe von dmesg nach dem modprobe?

Hallo

Danke für Deine Antwort. Anbei meine dmesg ausgabe.

Kannst Du mir mal die genauen Einträge in

/etc/modprobe.conf or into a new file /etc/modules.d/ipw3945:

zeigen

Gruss Heiko


ipw3945: disagrees about version of symbol ieee80211_wx_get_encodeext
ipw3945: Unknown symbol ieee80211_wx_get_encodeext
ipw3945: disagrees about version of symbol ieee80211_wx_set_encode
ipw3945: Unknown symbol ieee80211_wx_set_encode
ipw3945: disagrees about version of symbol ieee80211_wx_get_encode
ipw3945: Unknown symbol ieee80211_wx_get_encode
ipw3945: disagrees about version of symbol ieee80211_txb_free
ipw3945: Unknown symbol ieee80211_txb_free
ipw3945: disagrees about version of symbol ieee80211_wx_set_encodeext
ipw3945: Unknown symbol ieee80211_wx_set_encodeext
ipw3945: disagrees about version of symbol ieee80211_wx_get_scan
ipw3945: Unknown symbol ieee80211_wx_get_scan
ipw3945: disagrees about version of symbol ieee80211_freq_to_channel
ipw3945: Unknown symbol ieee80211_freq_to_channel
ipw3945: disagrees about version of symbol ieee80211_set_geo
ipw3945: Unknown symbol ieee80211_set_geo
ipw3945: disagrees about version of symbol ieee80211_rx
ipw3945: Unknown symbol ieee80211_rx
ipw3945: disagrees about version of symbol ieee80211_get_channel
ipw3945: Unknown symbol ieee80211_get_channel
ipw3945: disagrees about version of symbol ieee80211_channel_to_index
ipw3945: Unknown symbol ieee80211_channel_to_index
ipw3945: disagrees about version of symbol ieee80211_rx_mgt
ipw3945: Unknown symbol ieee80211_rx_mgt
ipw3945: disagrees about version of symbol ieee80211_get_geo
ipw3945: Unknown symbol ieee80211_get_geo
ipw3945: disagrees about version of symbol free_ieee80211
ipw3945: Unknown symbol free_ieee80211
ipw3945: disagrees about version of symbol ieee80211_tx_frame
ipw3945: Unknown symbol ieee80211_tx_frame
ipw3945: disagrees about version of symbol ieee80211_is_valid_channel
ipw3945: Unknown symbol ieee80211_is_valid_channel
ipw3945: disagrees about version of symbol ieee80211_get_channel_flags
ipw3945: Unknown symbol ieee80211_get_channel_flags
ipw3945: disagrees about version of symbol alloc_ieee80211
ipw3945: Unknown symbol alloc_ieee80211

Geh einmal nach dem Howto im Wiki vor und installiere wie dort beschrieben das ieee80211-Subsystem.