Ich habe mir vor kurzem ein Notebook zugelegt (Acer Aspire 5010) und wollte parallel zu Windows noch Suse 9.3 64Bit installieren. Hat soweit alles funktioniert, bis auf die Wlan Karte von Broadcom.
Ich habe mich an das How to do gehalten und die Installation hat auch ohne Fehlermeldung funktioniert. Nur die Broadcom Wlan Karte will einfach nicht laufen.
Hier ein paar Auszüge:
Befehl dmesg bringt:
iwconfig bringt:
ESSID hab ich in Yast gesetzt, wird aber nicht angezeigt. Keine Ahnung warum
iwlist bringt:
Weiß jemand, wo der Hund begraben ist? Wäre echt toll, wenn mir jemand helfen könnte.
Ich habe mich an das How to do gehalten und die Installation hat auch ohne Fehlermeldung funktioniert. Nur die Broadcom Wlan Karte will einfach nicht laufen.
Hier ein paar Auszüge:
Befehl dmesg bringt:
ndiswrapper: module not supported by Novell, setting U taint flag.
ndiswrapper version 1.2 loaded (preempt=no,smp=no)
ndiswrapper: driver bcmwl5 (Broadcom,02/11/2005, 3.100.64.0) loaded
ACPI: PCI interrupt 0000:02:05.0[A] -> GSI 21 (level, low) -> IRQ 169
ndiswrapper: using irq 169
ieee1394: Host added: ID:BUS[0-00:1023] GUID[000ae40518602951]
wlan0: ndiswrapper ethernet device 00:0e:9b:c4:83:73 using driver bcmwl5, config
uration file 14E4:4318.5.conf
wlan0: encryption modes supported: WEP, WPA with TKIP, WPA with AES/CCMP
iwconfig bringt:
lo no wireless extensions.
Warning: Driver for device wlan0 recommend version 18 of Wireless Extension,
but has been compiled with version 17, therefore some driver features
may not be available...
wlan0 IEEE 802.11g ESSIDff/any Nickname:"linux"
Mode:Ad-Hoc Frequency:2.412 GHz Cell: 00:00:00:00:00:00
Bit Rate=54 Mb/s Tx-Power:25 dBm
RTS thrff Fragment thrff
Encryption keyff
Power Managementff
Link Quality:100/100 Signal level:-10 dBm Noise level:-256 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
eth0 no wireless extensions.
sit0 no wireless extensions.
ESSID hab ich in Yast gesetzt, wird aber nicht angezeigt. Keine Ahnung warum
iwlist bringt:
linux:/home/geli/80211g_-64 # iwlist
Usage: iwlist [interface] scanning
[interface] frequency
[interface] channel
[interface] bitrate
[interface] rate
[interface] encryption
[interface] key
[interface] power
[interface] txpower
[interface] retry
[interface] ap
[interface] accesspoints
[interface] peers
[interface] event
Weiß jemand, wo der Hund begraben ist? Wäre echt toll, wenn mir jemand helfen könnte.